As of December 1, 2020, Focal Point is retired and repurposed as a reference repository. We value the wealth of knowledge that's been shared here over the years. You'll continue to have access to this treasure trove of knowledge, for search purposes only. Moving forward, myibi is our community platform to learn, share, and collaborate. We have the same Focal Point forum categories in myibi, so you can continue to have all new conversations there. If you need access to myibi, contact us at myibi@ibi.com and provide your corporate email address, company, and name.
Is there any way to "restart" the channel using XDControlAgent in iWay 5.5. I am able to stop the channel using the above service,but I am unable to restart the same immediately after stopping inside a p-flow.
Meaning stop and sudden start of channel from a p-flow.
Is there any way to do the same
Also is there any way to pause the flow inside a designer for quite a few seconds.
Regards GKThis message has been edited. Last edited by: Gopal_mys,
I checked with our iWay people and here is the feedback: In general the XDControlAgent does allow for the stopping and starting of a channel, and if you are using it within the same channel that you are stopping to restart, that would not work. In order to further investigate why this is not working for you, please get the pflow and logs, then open a case with Customer Support Services, by either call 1-800-736-6130, or access online at InfoResponse.
Cheers,
Kerry
Kerry Zhan Focal Point Moderator Information Builders, Inc.
Posts: 1948 | Location: New York | Registered: November 16, 2004