When I set a dimension grouping other than the top level it only drill down one level then it won't drill any farther. Is this normal functionality or is something not working properly?

When I do a grouping on Division I can only drill to sub division.

Usually this happens if PMF doesn't detect any data at the lower level for the measure in question.

What are you drilling on... a grid, a particular chart, etc?

thanks

I am drilling on a tree map. When grouping by division. It will drill to sub division just fine, but when I try to drill again to see cost center group it stops drilling.

When the grouping is turned off I can drill from business segment all the way down to cost center.

Thanks.

It depends on the measure you're drilling and if it has data going down to the level you're drilling, mostly.

We're adding "toaster" pop-up messages that respond to your drills so that stuff becomes crystal clear.

thanks