[CLOSED]run deferred using values are procedure names
I have a launch page that has check boxes which correspond to procedures. I would like to allow the end user to select all the check boxes and kick off running the reports using the run deferred button. The Run Now button works fine, and is only enabled if a single checkbox is checked. What I don't understand is, the run deferred option on the run deferred button is not available the minute you choose the action "Procedures from control". I would think that is when you'd want to run deferred. Otherwise, it runs the reports one after another and can cause multiple issues. Is there a workaround for this?
Thank you,This message has been edited. Last edited by: <Emily McAllister>,
8.0.0.8 Linux/windows
December 14, 2015, 12:17 PM
Tamra
Kris,
As a follow-up to your post have you found a way to resolve what you are looking for?
If you continue to require assistance on your deferred button can you please open a case at TechSupport Center.
More information may be required in order to provide a proper solution.
Thank you for participating in the Focal Point Forum.