Hello, Can someone please clarify me on following question? bargroupgapwidth is measured in what units? 0.2 in pixel or points or any other? Because i have spec in pixels so just trying to understand.This message has been edited. Last edited by: FP Mod Chuck,
"barGroupGapWidth": number Is a number between 0.0 and 1.0 that defines the width of the gap between groups of risers, as a percent of the available space between the groups. The default value is 0.2.
So it is a percent...This message has been edited. Last edited by: FP Mod Chuck,
Thank you for using Focal Point!
Chuck Wolff - Focal Point Moderator WebFOCUS 7x and 8x, Windows, Linux All output Formats
August 07, 2020, 02:27 AM
WF Learner
Thank you Chuck. Can we not change the bar width instead of the gap between bars? If so please guide me.
August 07, 2020, 11:05 AM
FP Mod Chuck
Kokila
I think on page 323 of the manual I linked you to should be the answer. I did not try it though...
Thank you for using Focal Point!
Chuck Wolff - Focal Point Moderator WebFOCUS 7x and 8x, Windows, Linux All output Formats