TABLE FILE CAR
PRINT
SALES
WHERE RECORDLIMIT EQ 5
ON TABLE HOLD AS X1
END

TABLE FILE CAR
PRINT
MODEL
WHERE RECORDLIMIT EQ 5
ON TABLE HOLD AS X2
END

TABLE FILE X1
PRINT
SALES
END

TABLE FILE X2
PRINT
MODEL
END

When i execute the above code i am able to see only the first the file o/p ie. file X1 and X2 is not getting printed at all.Can any1 lemme know the reason why its behaving in this manner and suggest a solution for this problem.Is it a version related problem if so the version im using currently is 7.6.4

This message has been edited. Last edited by: Kerry,

I get both reports. I'm on 7.6.5.

I've seen this behaviour only from within DevStudio, and then only if you execute the procedure with the message viewer on. Otherwise it shows all requests one after the other.

Do you indeed use DevStudio to run this?

yah..im running it from the devstudio only..

Then, switch off the message viewer, if you have it activated. If you do not have it active, then something strange is going on and you need to investigate further.
You can switch the message viewer off by checking the little black down pointing arrow to the right of the blue run arrow.

Hope this helps ...