Looks like the first ; is for the concat.

Majid, try putting a -EXIT at various points in your program to determine which part is failing. Then when you identify that, comment out bunches of code and re-add in steps to figure out what is causing the crash.

This is called the brute-force method, tedious but it works.

There are also some syntax errors on your style statements, particularly the final one.

As you have two reports, split them out into separate fexes and run the first one to ensure that works OK and is not causing your abort.

Also, how many DEFINEs do you have althogether and is it exceeding any limitation (you'll need to research that one).

T

You might want to start off by removing the stylesheet first and see if the report continues to run.

Hi,

Thanks to all of you for your quick reply.
I will consider with big interest all of your suggestions.
But one thing is very strange: the report sometimes returns data and sometime it crashes the server.
Note: I run the report with the same parameters.

Regards.

Majid.

Sometimes, if you wind up running in the same agent and your report uses up CPU, the CPU number in the agent is cumulative and does not refresh with each connection. At some point you will reach the established threshhold for that agent and it will die. However, you usually get a different message when that happens.

For testing, try setting AGENT_REFRESH to 1 to see if the problem continues to happen.

Majid,

I just had a problem with agents crashing and wanted to share this with you. My problem turned out to be my defin's.

I was using the edatemp area(no filedef's) to contain my processed information...how I was usinf a filedef pointing to a specific looped result and trying to relate the two...this caused eda to become confused...thus crashing agents...

If you are doing something like this either use all edatemp or all filedef'd hold areas.

Timothy Brydie

Hi Tony,

Can you tell me which error i have style statement

Thanks

Dear All,

I notice when i remove this from my code then it works.
When I put it back it crashes.

Can please suggest with what should i replace it.

This is added by dev studio-
TYPE=REPORT,
BY=2,
LINE=1,
OBJECT=TEXT,
ITEM

regards.

I am guessing that the type should not be REPORT. This should probably be SUBHEAD based on the fact that you have included a BY=. You may also want to either specify the actual column name on the BY= or give it a valid column reference such as B2, N2, P2. I don't know if BY=2 is valid. I am assuming there is additional content in this specific section of stylesheet as it is not complete.

P.S. When you post all 1200+ lines of code, it takes a while to get to the bottom of the post. And I wouldn't expect someone to go through that whole piece of code looking for a syntax error. Try narrowing things down a bit and then post appropriate sections of code. If more is needed, someone will ask for it.

Majid, as Ginny, Tony, & Darin so astutely pointed out you have alot going on here.
1. Remove stylesheet - decision time. Works consistently? then problem in stylesheet. If not, time to subdivide your code into sections and test it section by section. Good luck. Ira


aix 533 wf 5.37 (prod) wf 7.6 (test)