here's a weird one. I have a little dashboard. It has a few dropdowns for selection and a run Button. Below the dropdowns is the dashboard area with 3 tabs:

1)Tab 1 - Contains an FML Report

2) Tab 2 - Contains a regular HTML Report

3) Tab 3 - Contains two simple graphs

I hit the run button and everything quickly refreshes. I see my FML data on the default tab, tab1. I click tab 2 and see more data. I click tab 3 and see my graphs but they are squished.

If I hit the run button again, while on tab 3 (graph tab)...it refreshes and renders the graphs fine. In fact the only time the graphs render ok is if I hit run while on the graph tab. Otherwise they appear squished.

Ideas?

This message has been edited. Last edited by: FP Mod Chuck,

any ideas?

What's your setting for ON GRAPH SET AUTOFIT?

I do not have that code in my graphs at all..perhaps that is an issue? I do not see it in the fex as a set option; ie click the diamond then SET etc.

or is it an option in the GUI for the graph itself..

Neither the OFF nor ON setting makes a difference in how the graph renders on the 3rd tab.

If I default the form to open to the 3rd tab where the graph resides its fine. If it opens to the other tabs (desireable) then its squished until you hit refresh while on the graph tab.

Any way to fix this?

FYI, when I say tabs, these are tabs within a single form.

Any one have any ideas...right now I have to put a note on the tab saying to click the run button again...does not leave the tool in a good light....I cannot figure out why this happens....

Robert

If you haven't you should open a case with techsupport to see if they have a solution.

quote:

Neither the OFF nor ON setting makes a difference in how the graph renders on the 3rd tab

I have seen that the AUTOFIT is duplicated when using the GUI. So, edit it text and verify that it's only in there once. If not, removed the 2nd occurrence of it.

Hi Robert,

Please expand upon your release - WebFOCUS 8 is not precise enough

Also please explain how you have built your "Dashboard" - e.g. is it a Portal on which you are dropping resources from the resource tree, adding them as a new Tab each time?

I have just added three reports / charts into a Portal Page and have no issue, so we need more information (as always ) to be able to advise.


T

wf8008

AUTOFIT is nowhere to be found.

Its on our portal. On major Tab called: Reports, then criteria sits at the top then there are 3 tabs below on same page. 2 Data tabs and the graph. I had to default the thing opening to the graph to get it to display correctly. Of course if the user goes to a data tab and picks new criteria and refreshes from there....its squished again. You must be on the graph subtab for it to refresh correctly.

quote:

wf8008

Ok, that's earlier than I have available to me so I can't advise unfortunately.

I don't suppose an upgrade is in the pipeline for your company?

Unless someone out there has 8.0.08 still and can try it, I would suggest contacting Tech Support maybe?


T